Laser cutting wood can be a tricky thing. Especially when the wood becomes thick like these 3/8″
thick Mahogany trivets. The images are laser engraved first. There are infinite design possibilities. Next the laser is set up in vector mode and run at full power with slow speed and plenty of air to prevent “flare-up”. One complete the trivets are cleaned and finished before getting “feet”. Finally they are ready for the kitchen table.
Thes Factory Carts came to us in rather rough condition and needed completely new decks before putting them into full retail service:Completed Factory Cart #1: The deck was replaced with worm-scarred Maple to maintain the antique look.Completed Factory Cart #2: The before view of factory cart #1. This cart needed a full deck replacement along […]
Hidden Horse Acres:Laser Engraved Cypress and Hand Painted with One-Shot sign paints. Fresh off the Laser: Adding the Sign Top and Bottom: One of Many coats of Primer: Adding Colors:Completing the Insert: Starting to Hand-Paint the Letters:
Magnetic-backed nametags have been a popular product for quite a few years. Newer versions on brushed-aluminum have been popular as well. The tags can be backed with pins or magnets.
